aidez moi et merci d'avance
]]>Anyway I can understand the vc++ issue. So if the binary only is not enough and the installer too much, I advice you to ask entreprise db or bigsql how to solve your problem, since it's their installers, not community one.
]]>When you install PostgreSQL using an installer, it adds the PostgreSQL entries into the registry and creates an Uninstaller.exe as well which is not done using Binaries. Also, I would need to install VC++ environment separately, which I dont want to do and thus using an installer.
I used the same script in PG9.3 and it only installed the DB onto the system. It did not create the DB service or run dbinit during the time of installation. So, I am looking for installting PostgreSQL 9.5 using the installer but want to skip the initdb and service creation part (If Possible).
Thanks
]]>This is a french board. Anyway, you're probably looking for the binaries only, not the installer: http://www.enterprisedb.com/products-se … indownload
]]>"postgresql-9.5.4-1.exe --serviceaccount postgres --servicepassword DataBase1 --servicename PostgreSQL95 --prefix C:\Database\postgresql --datadir C:\Database\datadir\postgresql --mode unattended"
When I execute this script, it runs the initdb, creates the DataDir (i.e. C:\Database\datadir\postgresql) , also creates the PostgreSQL95 service and starts it which was not the case with PostgreSQL 9.3 . I used the same script for 9.3 and it did not 1. Run the initdb and created the data directory 2. Register the DB service and start it during the time of installation.
I wanted to know if there is a way to just install PG9.5 without running initdb and getting the DB service registered?
I do not want to use the --extract-only option.
Thanks
]]>